Toro Workman HD Series, Service Manual, Page: 55 / 318

Workman HDX--D
Page 4 -- 9
Briggs/Daihatsu Diesel Engine
Fuel Tank Removal (Fig. 6)
1. Park vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder.
3. Disconnect wire harness connector from fuel sender
on fuel tank.
4. Note routing of fuel hoses for installation purposes
(Fig. 7). Disconnect fuel hoses from fuel sender and rol-
lover valve. Plug fuel hoses to prevent leakage or con-
taminant entry.
5. Remove washer head screws (item 7) and retainer
plate (item 18) that secure fuel tank.
6. Remove fuel tank from vehicle.
Fuel Tank Installation (Fig. 6)
1. Position fuel tank to support tube.
2. Remove plugs placed in fuel hoses during fuel tank
removal. Connect fuel hoses to fuel sender and rollover
valve (Fig. 7). Secure fuel hoses with hose clamps.
3. Connect wire harness connector to fuel sender.
4. Position retainer plate (item 18) to tank and frame.
Make sure that fuel hoses are correctly placed under re-
tainer. While pressing down on retainer plate to best re-
tain tank, install and tighten washer head screws (item
7) to secure fuel tank.
5. Lower or install the bed or other attachment(s).
6. Fill fuel tank. Check for fuel leakage and correct if
found.
Figure 7
1. Retainer plate
2. Fuel supply hose
3. Tank vent hose
1
2
3
Briggs
/Da
iha
ts
u
Diesel
En
g
in
e