Toro Workman HD Series, Service Manual, Page: 194 / 318

Workman HD Series Page 8 -- 14 Electrical System
3rd -- High Lockout Key Switch
The 3rd -- High lockout key switch has two positions:
SLOW (turtle) and FAST (rabbit). This switch is located
on the dash (Fig. 16).
Testing
The switch terminals are identified as shown in Figure
17. The circuit wiring of the switch is shown in the chart
below. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various switch terminals
for each switch position. Disconnect wire harness con-
nector from 3rd -- High lockout key switch and verify con-
tinuity between switch terminals.
NOTE: The 3rd -- High lockout key switch terminals B
and C are not used on Workman HD series vehicles.
POSITION CIRCUITS
SLOW B + C
FAST B + C, A + D
After testing is completed, connect wire harness con-
nector to the 3rd -- High lockout key switch.
1. Dash 2. 3rd--High key switch
Figure 16
1
2
SLOW
FAST
45
o
Figure 17