Toro TITAN ZX6020, Operator'S Manual, Page: 50 / 60

Installing the Mower
Installing 54 inch Mower Decks
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the neutral
lock position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Place the height-of-cut pin in the lock position for
lowest height-of-cut.
6. Lift the rear of the mower deck and guide the hanger
brackets over the rear hanger bolts (Figure 72).
7. Attach the front support on the mower deck to the
front deck hangers, and secure them with a washer and
hairpin cotter (Figure 72).
8. Install the mower belt onto the engine pulley; refer to
Replacing the Mower Belt (page 47).
Installing 60 inch Mower Decks
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the neutral
lock position, stop the engine, remove the key, set the
parking brake and wait for all moving parts to stop
before leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Place the height-of-cut pin in the lock position for
lowest height-of-cut.
6. Lift the rear of the mower deck and attach the
rear support on the mower deck to the rear deck
hangers. Secure them with a washer and hairpin cotter
(Figure 74).
7. Attach the front support on the mower deck to the
front deck hangers, and secure them with a washer and
hairpin cotter (Figure 74).
8. Install the long, link bar through the frame hanger and
deck.
9. Secure the link bar with the hair pin cotters and washers
removed previously (Figure 73).
10. Install the mower belt onto the engine pulley; refer to
Replacing the Mower Belt (page 47).
Replacing the Grass Deflector
Service Interval: Before each use or daily—Inspect the grass
deflector for damage
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator’s or
bystander’s direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
mulch plate, discharge deflector, or grass collection
system.
Inspect the grass deflector for damage before each use.
Replace any damaged parts before use.
1. Disengage the spring from the notch in the deflector
bracket and slide the rod out of the welded deck
brackets, spring, and discharge deflector (Figure 75).
g017724
1
2
3
4
5
Figure 75
1. Deflector assembly 4. Spring
2. Deck brackets 5. Spring installed over the
rod
3. Rod
2. Remove the damaged or worn discharge deflector.
3. Position the new discharge deflector assembly with the
bracket ends between the welded brackets on the deck
as shown in Figure 75.
4. Install the spring onto the straight end of the rod.
Position the spring on the rod as shown in Figure 75 so
50