Toro TITAN ZX6020, Operator'S Manual, Page: 48 / 60

1 2
3
G02031 1
Figure 68
1. Loosen the screws 3. Remove belt cover
2. Pivot the belt cover up
5. Using a spring removal tool (Toro part no. 92-5771),
remove the idler spring from the deck post to remove
tension on the idler pulley (Figure 69).
A B
C D
1
2
3
4
5
G020312
Figure 69
1. Spring removal tool (Toro
part no. 92-5771) 4. Idler arm
2. Idler spring 5. Mower belt
3. Deck post
6. Lower the mower to the lowest height-of-cut.
7. Place the height-of-cut pin in the lock position for
lowest height-of-cut.
8. Remove the belt from the mower deck pulleys and
remove the existing belt.
Installing the Belt
1. Install the new belt around the mower pulleys and the
clutch pulley under the engine (Figure 69).
2. Using a spring removal tool (Toro part no. 92-5771),
install the idler spring over the deck post and place
tension on the idler pulley and mower belt (Figure 69).
3. Ensure that the belt is properly seated in all pulleys.
4. Install the belt covers (Figure 70).
A B
C
G020313
1
2
3
Figure 70
1. Position the belt cover and
ensure that the tabs seat. 3. Tighten the screws
2. Pivot the belt cover down
Removing the Mower
Park the machine on a level surface and disengage the blade
control switch. Move the motion control levers outward to
the neutral position, engage parking brake, stop the engine,
remove the key, and wait for all moving parts to stop before
leaving the operating position.
Lower the mower to the lowest height-of-cut. Select one of
the following procedures depending on the mower deck size
installed to complete the removal.
Preparing to Remove the Mower Deck
1. Lower the mower to the 76 mm (3 inch) height-of-cut
position.
2. Remove the mower belt from the engine pulley; refer
to Removing the Belt (page 47).
48