5.
Sit on the seat and start the engine. Engage the blade
control switch and let the mower run for 1 to 3 minutes.
6.
Disengage the blade control switch, stop the engine,
and remove the ignition key. Wait for all moving parts
to stop.
7.
Turn the water off and remove the coupling from the
washout fitting.
Note:
If the mower is not clean after one washing,
soak it and let it stand for 30 minutes. Then repeat the
process.
8.
Run the mower again for one to three minutes to
remove excess water.
WARNING
A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact. Contact with blade or thrown
debris can cause injury or death.
•
Replace broken or missing washout fitting
immediately, before using mower again.
•
Never put your hands or feet under the
mower or through openings in the mower.
Waste Disposal
Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
Storage
Cleaning and Storage
1.
Disengage the blade control switch (PTO), set the
parking brake, and turn the ignition key to Off.
Remove the key.
2.
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine cylinder head fins and blower
housing.
Important:
You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3.
Check the parking brake operation; refer to
Operating the Parking Brake (page 21).
4.
Service the air cleaner; refer to
Servicing the Air Cleaner (page 32).
5.
Grease the machine; refer to
Greasing the Bearings (page 31).
6.
Change the crankcase oil; refer to
Servicing the Engine Oil (page 33).
7.
Check the tire pressure; refer to
Checking the Tire Pressure (page 40).
8.
Change the hydraulic filter; refer to
Changing the Hydraulic System Filter and Oil (page 40).
9.
Charge the battery; refer to
Charging the Battery (page 39).
10.
Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note:
Run the machine with the blade control switch
(PTO) engaged and the engine at high idle for 2 to
5 minutes after washing.
11.
Check the condition of the blades; refer to
Servicing the Cutting Blades (page 43).
12.
Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows:
A.
Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B.
Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
52
Summary of Contents for TITAN ZX6020
Page 56: ...Schematics G014723 Wire Diagram Rev B 56...
Page 57: ...Notes 57...
Page 58: ...Notes 58...
Page 59: ...Notes 59...