Slide hose clamps onto ends of fuel lines. Push fuel
lines onto fuel filter and secure them with hose clamps.
Be sure arrow on side of filter points toward the
carburetor.
!
,1&( *$52/,1( ,5 +,*+/: )/$00$%/( '4$,1 ,6
276'2245 $1' 0$.( 574( (1*,1( ,5 &22/ 62
34(8(16 $ 326(16,$/ ),4( +$;$4' #,3( 73
$1: *$52/,1( 6+$6 0$: +$8( 53,//(' 2 126
'4$,1 *$52/,1( 1($4 $1: 23(1 )/$0( 24
9+(4( *$52/,1( )70(5 0$: %( ,*1,6(' %: $
53$4. 2 126 502.( $ &,*$4 &,*$4(66( 24 $
3,3( 9+(1 +$1'/,1* *$52/,1(
!
"
!
,*
If the machine creeps" when the traction pedal is in
the neutral position, the traction cam must be
adjusted.
Park the machine on a level surface and turn the
engine off.
Pivot seat upward and remove engine shield.
Raise one rear wheel off floor and place support
blocks under frame.
Loosen locknut on traction adjustment cam.
,*74(
4$&6,21 $'-7560(16 &$0
2&.176
#
1*,1( 0756 %( 4711,1* 52 ),1$/ $'-7560(16 2)
6+( 64$&6,21 $'-7560(16 &$0 &$1 %( 3(4<
)240(' 2 *7$4' $*$,156 3255,%/( 3(4521$/
,1-74: .((3 +$1'5 )((6 )$&( $1' 26+(4 3$465 2)
6+( %2': $9$: )420 6+( 07))/(4 26+(4 +26 3$465
2) 6+( (1*,1( $1' 26+(4 426$6,1* 3$465
Start engine and rotate cam hex in both directions
to determine mid position of neutral span.
Tighten locknut securing adjustment.
Stop the engine.
Install engine shield and lower seat.
Remove jack stands and lower the machine to the
shop floor. Test drive the machine to make sure it does
not creep.
!
#
,*
Adjust transmission for neutral; refer to Adjusting
Traction Drive For Neutral, page 19.
Activate the pump lever to assure all parts are
operating freely and seated properly.
Rotate switch adjusting screw until there is a gap
between head of screw and switch button.
Rotate adjusting screw until it contacts the switch
button. Continue to rotate the screw until the circuit is
completed (switch clicks"). After the switch clicks,
rotate the adjusting screw an additional 1/2 turn.
Check for proper operation.
! #
,*
The pedal must be adjusted for forward if jam nuts on
control rod are loosened or if pedal is removed.
Park the machine on a level surface, turn engine off
and engage parking brake.
Make sure pump is in neutral.
Loosen jam nuts on control rod.
,*74(
('$/
$0 1765
21642/ 42'
Press down on rear of pedal until pedal contacts
footrest.
Adjust jam nuts to allow full stroke of pump slightly
deflecting control rod when pedal is at full stroke.
Summary of Contents for Sand Pro 3020
Page 26: ... ...
