Figure 36
1.
Side panel
3.
Panel latch
2.
Anchor bracket
3.
Lift the side panel straight up and remove it from the
machine (Figure 36).
Installing the Side Panels
1.
Align the left side panel with the left side of the
machine and the right side panel with the right side
of the machine.
2.
Align the tabs at the top of the side panel with the
receiver brackets on the machine (Figure 37).
Figure 37
1.
Tab
3.
Receiver brackets
2.
Side panel
3.
Lower the side panel straight down.
Note:
Ensure that the tabs of the side panel align into
the receiver brackets on the machine.
4.
Pull the hand grip of the panel latch outward, then
pivot it up until it aligns in the anchor bracket (Figure
36).
5.
Release the latch handle.
6.
If the backhoe is installed on the machine, do the
following substeps:
A.
Rotate the front end of the walkway to its original
position (Figure 35).
B.
Align the hole in the walkway with the hole in the
walkway support bracket (Figure 35).
C.
Install the retaining pin through the holes.
Removing the Nose Panel
1.
Remove both the left side panel and the right side
panel from the machine; refer to Removing the Side
Panels (page 36).
2.
If the backhoe is installed on the machine, do the
following substeps; otherwise, skip to step 3.
A.
Remove the hairpin from the seat lock pin (Figure
38).
Figure 38
1.
Hairpin
2.
Seat lock pin
B.
Remove the seat lock pin from the frame of the
backhoe and the seat post (Figure 38).
C.
Pivot the seat post upward, and insert the
seat-lock pin through the holes in the frame of
the backhoe to hold the seat up to make room for
removing the nose panel (Figure 38).
Note:
Install the seat lock pin and hairpin in the
backhoe frame to hold the seat up position.
3.
Remove the 4 bolts at the bottom of the left and right
sides of the nose panel (Figure 39).
37
Summary of Contents for RT600
Page 71: ...Notes 71...
