g004144
Figure 22
1.
Chain bracket
3.
Cutting-unit kickstand
2.
Snapper pin
Installing the Front Cutting Units to the Lift
Arms
1.
Slide a cutting unit under the lift arm (
).
g375274
Figure 23
1.
Cap
3.
Lift-arm yoke
2.
Snapper pin
4.
Carrier frame shaft
2.
Assemble the lift-arm yoke onto the carrier frame
shaft.
3.
Assemble the cap to the pivot-arm shaft, and align
the holes in the carrier frame shaft, pivot arm shaft,
and cap.
4.
Secure the cap and the carrier-frame shaft to the
lift-arm yoke with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting Grass
on a Hill Side
—Lock the cutting-unit pivots to prevent
the cutting units from rotating downhill when cutting
across the face of a hill. Use the hole in the lift-arm
pivot shaft (
) to lock the cutting unit. Use the
slot for a steering cutting unit.
g375251
Figure 24
1.
Snap-pin positions
3.
Slot (lift-arm pivot shaft)
2.
Hole (lift-arm pivot shaft)
Installing the Rear Cutting Units to the Lift
Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch) or Higher
Height of Cut
1.
Slide a cutting unit under the lift arm (
).
g375252
Figure 25
1.
Cap
3.
Lift-arm yoke
2.
Snapper pin
4.
Carrier frame shaft
2.
Assemble the lift-arm yoke onto the carrier frame
shaft.
3.
Assemble the cap to the pivot-arm shaft, and align
the holes in the carrier frame shaft, pivot arm shaft,
and cap.
16
