Toro Reelmaster 5610-D, Owner'S Manual, Page: 11 / 84

2
Adjusting the Control-Arm Position
No Parts Required
Procedure
You can adjust the control-arm position for your comfort.
1. Loosen the 2 bolts securing the control arm to the
retaining bracket (
Figure 3 ).
g004152
Figure 3
1. Control arm 3. Bolt
2. Retaining brackets
2. Rotate the control arm to the desired position and
tighten the 2 bolts.
3
Installing the Cutting Units
Parts needed for this procedure:
1 Right front hose guide
1 Left front hose guide
Preparing the Machine
1. Remove the reel motors from the shipping brackets.
2. Remove and discard the shipping brackets.
3. At each cutting unit lift arm, remove the lynch pin that
secures the cap to the lift arm pivot yoke, and remove
the cap (
Figure 4 ).
g003975
Figure 4
1. Lynch pin 2. Cap
Preparing the Cutting Units
1. Remove the cutting units from the cartons.
2. Assemble and adjust as described in the cutting unit
Operator's Manual .
3. Make sure that the counterweight ( Figure 5 ) is
installed at the proper end of the cutting unit as
described in the cutting unit
Operator's Manual .
g003320
Figure 5
1. Counterweight
11