Toro Reelmaster 5210, Service Manual

Page: 119 / 304

Reelmaster 5010 Series Hydraulic System (Rev. C) Page 4 -- 87
11.If solenoid coil was removed:
A. Carefully install coil onto the cartridge valve.
B. Install nut and torque nut to 48 to 60 in--lb (5.4 to
6.7 N--m) .
12.If flow control cartridge valve was removed, install
rotary handle to valve stem (Fig. 72):
A. Place handle base on flow control valve and posi-
tion alignment mark on base with number 1 on man-
ifold. Secure base with two (2) set screws. Apply a
light coating of grease to chamfer on top of base to
ease seal installation.
B. Make sure that sleeve bearing is in handle cap. If
necessary, press sleeve bearing into cap. Install lip
seal on cap with seal lip facing down.
C. Place bushing onto cartridge valve stem. Use a
small amount of grease to keep bushing toward the
top of the valve stem.
D. Place compression spring and detent pin into
handle cap. Use a small amount of grease to hold
detent pin in place.
E. Make sure that flow control cartridge is closed by
rotating valve stem fully clockwise. During handle
installation, DO NOT rotate valve stem or speed ad-
justment will be incorrect.
F. Press handle cap onto valve stem with arrow on
cap pointing to number 9 on manifold. Make sure that
detent pin and spring stay positioned in cap.
G. While pressing on the cap to keep the lip seal in
place, rotate cap in a clockwise direction until the ar-
row on the cap aligns with number 1 on the manifold.
By rotating the cap clockwise, the valve will remain
closed. Install screw to retain cap.
H. Make sure that alignment marks on cap and base
are in line and that arrow on cap is pointing to number
1 on manifold. Tighten two (2) set screws to secure
handle cap.
Hydraulic System