Toro Reelmaster 3555, Operator'S Manual, Page: 64 / 76

A. Move the lower mow/raise control lever
rearward.
Note:
The cutting units shut off, but do not
raise.
B. Press the cutting unit drive switch to the
D
ISENGAGE
position.
C. Shut off the engine and remove the key.
D. Adjust to the cutting units.
E. Repeat steps 1 through 5 .
7. Repeat steps 4 for the other cutting units that
you want to backlap.
Finishing Backlapping
1. Press the cutting unit control switch to the
D
ISENGAGE
position.
2. Shut off the engine.
3. Move the backlap lever to the F (mow) position
(
Figure 99 ).
Important:
If you do not change backlap
lever to the F (mow) position after
backlapping, the cutting units will not raise
or function properly.
g020248
Figure 99
1. Backlap lever 2. Reel speed control knob
4. Adjust the cutting unit reel speed control to
setting that you noted in step
4 of Preparing the
Machine (page 62) .
5. Close the floor panel.
6. Wash all lapping compound off from the cutting
units.
7. For a better cutting edge, run a file across the
front face of the bedknife after lapping.
Note:
This removes any burrs or rough edges
that may have built up on the cutting edge.
64