Toro Reelmaster 3555, Operator'S Manual, Page: 16 / 76

g020321
Figure 10
1. Lift arm 3. Lift-arm pivot yoke
2. Carrier frame shaft
Aligning the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Higher Height of Cut
1. Remove the lynch pin and washer securing the
lift-arm pivot shaft to the lift arm and slide the
lift-arm pivot shaft out of the lift arm (
Figure 11 ).
g003979
Figure 11
1. Lift-arm shaft lynch pin and washer
2. Insert the lift-arm yoke onto the carrier frame
shaft (
Figure 10 ).
3. Insert the lift-arm shaft into the lift arm and
secure it with the washer and lynch pin (
Figure
11 ).
Assembling the Cutting Units to
the Lift Arms
1. Insert the cap over the carrier frame shaft and
lift-arm yoke.
2. Secure the cap and the carrier frame shaft to the
lift-arm yoke with the snapper pin.
Note:
Use the slot if a steering cutting unit is
desired or use the hole if the cutting unit is to be
locked in position (
Figure 9 ).
3. Secure the lift-arm chain to the chain bracket
with the snapper pin (
Figure 12 ).
Note:
Use the number of chain links specified
in the cutting unit Operator's Manual .
g003948
Figure 12
1. Lift-arm chain 3. Snapper pin
2. Chain bracket
Installing the Reel Motors
1. Coat the spline shaft of the reel motor with clean
grease.
2. Lubricate the reel-motor O-ring with oil, and
install it onto the motor flange.
3. Install the motor by rotating it clockwise so that
the motor flanges clear the locknuts (
Figure 13 ).
Important:
Ensure that the reel motor hoses
are not twisted, kinked, or at risk of being
pinched.
g020322
Figure 13
1. Reel-drive motor 2. Mounting nuts
16