Toro Reelmaster 3555, Operator'S Manual, Page: 36 / 76

6. Tighten the screw and turn the ignition key to
O
FF
.
Note:
The engine should start after you follow the
procedure above. However, if the engine does not
start, air may be trapped between the injection pump
and injectors; refer to
Bleeding Air from the Injectors
(page 47) .
Understanding the
Diagnostic Light
The machine is equipped with a diagnostic light
that indicates if the electronic controller senses an
electronic fault. The diagnostic light is located on
the control panel (
Figure 46 ). When the electronic
controller is functioning correctly and you move the
key switch to the O
N
position, the controller diagnostic
light turns on for 3 seconds and turn off to indicate
that the light is working properly.
If the engine shuts off, the diagnostic light illuminates
steady until the you change key position. The light
blinks if the controller detects a fault in the electrical
system. After you repair the fault, the light resets
when you turn the key switch to the O
FF
position.
g020251
Figure 46
1. Diagnostic light
Operating Tips
Becoming Familiar with the
Machine
Before mowing grass, practice operating the machine
in an open area. Start and shut off the engine.
Operate in forward and reverse. Lower and raise
the cutting units and engage and disengage the
cutting units. When you become more familiar with
the machine, practice operating up and down slopes
at different speeds.
Understanding the Warning
System
If a warning light comes on during operation, stop the
machine immediately and correct the problem before
continuing operation. Serious damage could occur if
you operate the machine with a malfunction.
After Operation
After Operation Safety
General Safety
•
Park the machine on a level surface.
•
Disengage and lower the cutting units.
•
Engage the parking brake.
•
Shut off the engine and remove the key.
•
Wait for all movement to stop.
•
Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Clean grass and debris from the cutting units,
drives, mufflers, cooling screens, and engine
compartment to help prevent fires. Clean up oil or
fuel spills.
•
Disengage the drive to the attachment whenever
you are hauling or not using the machine.
•
Maintain and clean the seat belt(s) as necessary.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Towing the Machine
In case of an emergency, you can tow the machine for
a short distance; however, Toro does not recommend
this as a standard procedure.
Important:
Do not tow the machine faster than
3 to 4 km/h (2 to 3 mph) because it may damage
the drive system. If you must move the machine
a considerable distance, transport it on a truck
or trailer.
1. Unlatch and open the hood.
2. Near the right hood latch, rotate the bypass-valve
handle on the pump 90° (
Figure 47 ).
36