Toro Reelmaster 3555, Operator'S Manual, Page: 52 / 76

4. If the coolant level is low remove the expansion
tank cap, add the specified coolant to the tank
until the coolant level is midway between the
marks on the side of the tank, and assemble the
cap to the tank.
Important:
Do not overfill the expansion
tank.
5. Close and latch the hood.
Cleaning the Engine
Cooling System
Service Interval: Before each use or daily
Remove debris from the oil cooler and radiator daily.
Clean them more frequently in dirty conditions.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 41) .
2. Raise the hood.
3. Clean the engine area thoroughly of all debris.
4. Remove the lower radiator shield ( Figure 72 ).
g352363
Figure 72
1. Radiator 2. Lower radiator shield
5. Clean both sides of the radiator area thoroughly
with water or compressed air (
Figure 72 ).
6. Install the lower radiator shield.
7. Close and latch the hood.
Brake Maintenance
Adjusting the Parking
Brake
Service Interval: Every 200 hours—Check the
adjustment of the parking brake.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 41) .
2. Loosen the setscrew securing the knob to the
parking-brake lever (
Figure 73 ).
g008923
Figure 73
1. Parking-brake lever 3. Set screw
2. Knob
3. Rotate the knob until a force of 133 to 178 N (30
to 40 lb) is required to actuate the lever.
4. Tighten the setscrew.
Servicing the Parking
Brakes
Service Interval: Every 400 hours
Preparing the Machine
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 41) .
2. Raise the front of machine.
3. Support the machine with jack stands rated
for the weight of your machine; refer to
Specifications (page 25) .
4. Repeat steps 2 and 3 at the other side of the
machine.
Removing the Front Wheels
1. Remove the 4 lug nuts that secure the front
wheel to the hub, and remove the wheel (
Figure
74 ).
52