Toro 41642, Installation Instructions Manual

Page: 2 / 16

Installing the Kit
1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
key from the starter switch.
2. Disconnect the negative (-) battery cable from the
battery.
3. Loosen the worm clamps that secures the manifold
coupler to the agitation valve and section valve
assembly (
Figure 1 ).
Figure 1
New flow meter shown
1. Worm clamp 4. Transducer clamp
2. Gasket 5. Cap
3. Flow meter
4. Remove the clamps, gaskets, and manifold coupler
(
Figure 1 ).
Note:
Retain the clamps.
5. Install the flow meter and 2 flow meter gaskets using
the clamps that you just removed (
Figure 1 ).
6. Remove the transducer clamp, cap, and gasket ( Figure
1 ).
7. Install the flange gasket, cap fitting, and pressure
transducer, securing them using the transducer clamp
that you just removed (
Figure 2 ).
Figure 2
1. Pressure transducer 3. Cap fitting
2. Transducer clamp 4. Flange gasket
8. Connect the pressure transducer connector from the
machine wire harness to the pressure transducer.
Figure 3
1. Pressure transducer
connector 2. Pressure transducer
2