Toro 41622, Installation Instructions Manual

Page: 8 / 20

3
Installing the Latching
Components
Parts needed for this procedure:
2 Spring
Installing the Springs
1. Install the spring in the hole in the lower end of the
angled tab on the side of the frame assembly (
Figure
10 ).
G 013931
1
2
3
4
5
Figure 10
1. Angled tab 4. Post
2. Hole in tab 5. Groove
3. Spring
2. Hook one end of the spring into the hole and the other
end onto the spring post (
Figure 10 ).
3. Make sure that the spring end is seated properly in the
groove in the post (
Figure 10 ).
4. Repeat steps 1 through 3 for the other side.
5. Tighten the 2 set screws in the left arm.
Adjusting the Tongue Position
Move the cradle assembly into the upper Transport position
to adjust the tongue.
1. Lift up on the handles to raise the assembly while
slightly tipping it toward the tank.
2. Guide the tongue under the crossbar with the welded
tab in the upper portion of the frame assembly.
3. Let the assembly pivot down, toward the tank.
4. Making sure that the plastic stops are in contact with
the spring tabs, apply enough pressure against the back
plate assembly of the cradle to compress the spring
tabs midway (
Figure 11 ).
Figure 11
1. Spring tab under pressure 3. Spring tab
2. Back plate
5. While maintaining the pressure on the back plate, slide
the tongue toward you until the lip of the tongue plate
contacts the crossbar (
Figure 12 ).
Figure 12
1. Tongue-plate lip
3. Slot in plate
2. Fasteners 4. Welded tab
6. Tighten the fasteners in the tongue to secure its
position, then release pressure on the back plate.
Note:
Check to see if there is any play in the cradle.
It should be held snug to the frame assembly. You can
repeat this procedure once the eductor is installed to
adjust the locked position.
8