Toro 41622, Installation Instructions Manual

Page: 4 / 20

Procedure Description Qty. Use
Bulkhead 1
O-ring 1
Locking ring 1
Retaining fork 2
Forward hose assembly 1
Gasket
1
Worm-screw clamp 1
R-clamp 1
Carriage bolt (5/16 x 1 inch) 1
5
Lock nut (5/16 inch) 1
Install the forward hose.
Supply hose 1
Gasket
1
Worm-screw clamp 1
Hose clamp 1
Hose adapter 1
6
Retainer pin 1
Install the supply hose.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Installing the Eductor Valve
and Hoses
Parts needed for this procedure:
1 Eductor valve assembly
2 Flange nut (1/4 inch)
1 Fitting (1 inch)
1 Retainer pins
1
Eductor valve bracket (The bracket may already be
installed from a previous kit installation)
1
Relief hose (10 3/4 inches)
1 Supply hose (18 1/2 inches)
1 Bypass hose (12 inches)
Procedure
1. Move to the rear of the machine and locate the boom
valve assembly on the boom valve mount bracket.
2. Remove and discard the 3 hoses shown in Figure 3 but
keep the retainer pins.
Figure 3
1. Remove and discard
3. Secure the eductor valve bracket to the boom valve
assembly using the bolts and nuts that secure the
pressure filter to the boom valve bracket; refer to Box
A of
Figure 4 .
4