Toro 41622, Installation Instructions Manual

Page: 5 / 20

Figure 4
1. Nuts (existing)
5. Eductor valve bracket
2. Eductor valve bracket 6. Eductor valve assembly
3. Bolts (existing) 7. Retainer pin
4. Flange nuts (1/4 inch) 8. Fitting (1 inch)
4. Install the eductor valve as shown in Box B of Figure 4 .
5. Install the 1-inch fitting into the eductor valve and
secure it with a new retainer pin; refer to box C of
Figure 4 .
6. Rotate the hose tee near the eductor valve 45° and
install the new bypass hose (
Figure 5 ).
Figure 5
1. Bypass hose 3. Pump tee
2. Relief hose 4. Supply hose
7. Remove the horizontal hose tee from the side of the
pump tee and attach it to the top of the pump tee
(
Figure 5 ).
8. Connect the supply hose to the side of the pump tee
and the bottom of the eductor valve (
Figure 5 ).
9. Connect one end of the relief hose to the upper pump
tee and the other to the lower tee near the eductor
(
Figure 5 ).
5