Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
Handle bolts
4
Curved washers
4
1
Locknuts
4
Install the upper handle.
2
No parts required
–
Install the wheel clutch cable ends
3
No parts required
–
Install the traction control linkage.
Carriage bolts
2
4
Locknuts
2
Install the chute control rod.
5
Cable tie
1
Connect the wire to the headlight.
6
No parts required
–
Fill the engine with oil.
7
No parts required
–
Check the tire pressure.
8
No parts required
–
Check the skids.
9
No parts required
–
Check the operation of the traction drive.
1
Installing the Upper Handle
Parts needed for this procedure:
4
Handle bolts
4
Curved washers
4
Locknuts
Procedure
Note:
Do not remove the rubber band on the cables
until you have installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important:
Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables and the wire for the
headlight are not pinched between the handle
sections.
Figure 3
1.
Cables
2. Secure the upper handle with 4 handle bolts,
4 curved washers, and 4 locknuts from the loose
parts bag (Figure 4).
7
Summary of Contents for 38597
Page 29: ...Notes 29 ...
Page 30: ...Notes 30 ...
