Toro 38597, Operator'S Manual

Page: 13 / 32

A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 11).
C. Turn the trunnion downward (clockwise) on the
speed control rod (Figure 11).
D. Connect the trunnion to the speed selector lever
(Figure 11).
4. Release the traction lever.
5. Move the speed selector to the Position 1; refer to
Operating the Speed Selector.
6. Squeeze the left hand (traction) lever to the hand-grip
(Figure 20).
The machine should move forward. If the machine
does not move or moves rearward, complete the
following:
A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 11).
C. Turn the trunnion upward (counterclockwise) on
the speed control rod (Figure 11).
D. Connect the trunnion to the speed selector lever
(Figure 11).
7. If you made any adjustments, repeat this procedure
until no adjustments are required.
Important:
If the machine moves when the traction
lever is in the released position, check the traction
cable (refer to Checking and Adjusting the Traction
Cable) or take the machine to an Authorized Service
Dealer for service.
Product Overview
Figure 21
1. Hand-grip (2) 10. Scraper
2. Auger/impeller lever 11. Auger
3. Speed selector lever 12. Skid (2)
4. Quick Stick™ discharge
chute control 13. Electric starter button (all
models except 38597)
5. Traction lever
14. Electric starter plug (all
models except 38597)
6. Fuel tank cap 15. Snow cleanout tool
7. Engine oil fill tube/dipstick 16. Headlight (models 38633,
38637, 38639, and 38657
only)
8. Chute deflector 17. Wheel clutch lever (2)
(models 38633, 38637,
and 38657 only)
9. Discharge chute
Figure 22
1. Choke 5. Recoil starter
2. Ignition switch 6. Oil drain plug
3. Fuel shutoff valve 7. Primer
4. Throttle
13