g012631
Figure 6
1.
Bolt
3.
Arm of hood-latch bracket
2.
Nut
3
Adjusting the Roller
Scraper (Optional)
No Parts Required
Procedure
The optional rear roller scraper is designed to work
best when there is an even gap of 0.5 to 1 mm (0.020
to 0.040 inch) between the scraper and roller.
1.
Loosen the grease fitting and the mounting
screw (
).
g011346
Figure 7
1.
Roller scraper
3.
Grease fitting
2.
Mounting screw
2.
Slide the scraper up or down until you attain
a gap of 0.5 to 1 mm (0.020 to 0.040 inch)
between the rod and the roller.
3.
Secure the grease fitting and screw to 41 N∙m
(30 ft-lb) in an alternating sequence.
4
Installing the Mulching
Baffle (Optional)
No Parts Required
Procedure
1.
Thoroughly clean debris from the mounting holes
on the rear wall and left wall of the chamber.
2.
Install the mulching baffle in the rear opening
and secure it with 5 flange-head bolts (
).
g011347
Figure 8
1.
Mulching baffle
3.
Verify that mulching baffle does not interfere with
the tip of the blade and does not protrude inside
the surface of the rear chamber wall.
DANGER
Using the high-lift blade with the
mulching baffle could cause the blade
to break, resulting in personal injury or
death.
Do not use the high-lift blade with the
mulching baffle.
13
