
8
Setup Instructions
Mount Hose Clamp
1. Using dimensions shown in figure 1, locate, mark and
drill (2) .28 in. dia. holes in traction unit platform. Use
caution when drilling as there are hoses and cables
under platform.
.75”
4.41”
12.75”
Figure 1
2. Secure hoses to under side of platform with clamp, (2)
brackets, capscrews and nuts. Position brackets to fit
contour of hoses and platform.
1
2
Figure 2
1.
Clamp
2.
Bracket
Grass Deflector
1. Remove shipping bands allowing deflector to be
lowered.
Deflector is spring loaded in the down
position and will rotate downward, if not
retrained, when band is cut. If done
improperly, personal injury may occur.
Warning
1
Figure 3
1.
Grass deflector
Mount Rear Castor Wheels
The rear castor wheels are shipped secured upside down to
deck brackets.
1. Remove capscrew and locknut securing front of rear
castor pivot to deck bracket.
1
Figure 4
1.
Rear castor pivot arm
2. Turn pivot right side up and secure front of castor pivot
arm to front of deck bracket with capscrew and locknut
removed.
3. Align the pivot arm holes with selected height-of-cut
bracket holes in the deck frame, install clevis pin and
secure with hairpin cotter.
4. Repeat procedure on other castor wheel assembly.
Connect Right-hand Push Arm
To Cutting Unit
Note: Ball joints are shipped with traction unit.
1. Thread a jam nut fully onto ball joint.
Summary of Contents for 30799
Page 18: ...18 Trouble Shooting 85 T o 110...