
6
Specifications
Note: Specifications and design subject to change without notice.
General Specifications
Configuration
Three blades, one blade center section, and two 1 blade floating wings. Wings flex
up and down 12 degrees in a single plane perpendicular to from center section.
Height of Cut
Adjustable front and rear, in .50 inch increments from 1 to 4 inches.
Construction
12-gauge steel, 5.25 inches deep, welded construction and reinforced with
10-gauge steel channels.
Blades
Three 25 inch long, .25 inch thick, heat treated steel blades.
Cutter Drive
PTO driven gearbox with 1.26–1 spiral bevel gears. One “B” section belt on center
section. One “B” section belt on each wing. Center section tensioned through
spring loaded idler. Wings tensioned through adjustable fixed idler.
Spindles
Cast iron housing, 1-1/4 inch dia shaft with welded blade retainer. Turning on two
greaseable tapered roller bearings. A positive splined connection attaches pulley to
spindle shaft.
Castor Wheels
Front: Four 8 inch pneumatic wheels with greaseable roller bearings. Rear: Two 8
inch pneumatic wheels with greaseable roller bearings (one on each wing). Center
section suspended from push arms.
Anti Scalp
Anti-scalp cup (11 inch diameter) located on each blade. One anti-scalp roller on
rear of center section. Adjustable skid on right wing.
Trimability
34, uncut circle, 25, uncut circle with use of individual wheel brakes.
Tip Speed
15,000 ft./min. @ 3200 engine RPM.
Discharge
Left-hand, side discharge (recycler kit available).
Belt Covers
Steel covers bolted down, meets CE requirements.
Weight
550 lb.
Width
83-1/2 in.
Optional Equipment
High Lift Blade
Part No. 23-2410
Height of cut spacers 1/4
Part No. 54-8810
Foam Filled 8” Tire
Recycler Kit
Atomic Blade
Part No. 93-5974
Model No. 30838
Part No. 106–4354
Summary of Contents for 30799
Page 18: ...18 Trouble Shooting 85 T o 110...