Toro 30669, Installation Instructions Manual

Page: 9 / 20

Installing the Sunshade
Groundsmaster 360 or 7200
Machines
1. With the roll bar in the raised position, remove
the hairpin cotters and the 2 pins (
Figure 19 ).
g187726
Figure 19
1. Pin
3. Roll bar (raised position)
2. Hairpin cotter 4. Roll bar (lowered position)
2. Insert a washer (13/16 x 1-1/2 inches) onto each
bolt (3/4 x 4 inches) as shown in
Figure 20 .
g018099
Figure 20
1. Nut (3/4 inch) 3. Washer (13/16 x 1-1/2
inches)
2. Roll bar 4. Bolt (3/4 x 4 inches)
3. In the holes where the pins were removed,
install the bolts and washers (
Figure 20 ).
4. Install another washer onto each bolt and
secure with nuts (3/4 inch) as shown in
Figure
20 . Torque the nuts 323 to 396 N∙m (238 to 292
ft-lb).
5. Torque the ROPS pivot bolt ( Figure 20 ) 91 to
113 N∙m (67 to 83 ft-lb) to avoid any bouncing of
the roll bar and sunshade.
6. Position the ROPS-mount bracket onto the top
of the traction unit roll bar (
Figure 21 ).
Note:
Make sure that the roll bar is centered in
the ROPS-mount bracket.
g246185
Figure 21
1. Bolt (1/2 x 2-1/2 inch) 3. Flange nut (3/8 inch)
2. Flange nut (1/2 inch) 4. U-bolt (4-7/8 x 2-3/4 inch)
7. Using the mounting holes shown in Figure 21 ,
mount the bracket to the top of the roll bar with 2
U-bolts (4-7/8 x 2-3/4 inch) and 4 flange nuts.
8. Using the mounting holes shown in Figure 22 ,
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 2-3/4 inches)
and 2 flange nuts.
9