Toro 30669, Installation Instructions Manual

Page: 18 / 20

g245151
Figure 45
1. Flange-head bolt (5/16 x
1-1/4 inches) 3. Grommet
2. Small washer 4. Clip nut
10. Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches), a small washer, and a grommet (
Figure
45 ).
11. Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
Operation
Transporting the Machine
When transporting the machine, use the 2 holes in
the front of the sunshade frame (under the sunshade)
to tie down the sunshade to a secure location on the
machine and prevent it from raising up in the wind
(
Figure 46 ).
g018101
Figure 46
1. Tie down holes
Maintenance
Checking and Tightening
the Hardware
Check and tighten the mounting hardware after 8
hours of operation. Periodically inspect and tighten
the hardware.
Cleaning the Sunshade
Wash with a mild soap or detergent using your bare
hands, soft cloth, or sponge to free or dislodge any
caked-on dirt or other foreign particles.
Note:
Using some cleaners or cloths may scratch or
degrade the surface of the sunshade. Test the cleaner
or cloth in an inconspicuous area.
18