![Toro 30669 Installation Instructions Manual Download Page 4](http://html1.mh-extra.com/html/toro/30669/30669_installation-instructions-manual_1133728004.webp)
g246184
Figure 3
1.
Flange nut (3/8 inch)
2.
U-bolt (3-7/8 x 4 inches)
5.
On each side of the sunshade frame, loosely
mount a brace to the second hole of the brace
mount with a bolt (1/2 x 2-3/4 inches), washer
(1/2 inch), and flange nut (1/2 inch) as shown
in
g267172
Figure 4
Left side shown
1.
Flange nut (1/2 inch)
5.
Bolt (1/2 x 2-1/2 inches)
2.
Mount hole
6.
Brace bracket
3.
Washer (1/2 inch)
7.
Brace
4.
Bolt (1/2 x 2-3/4 inches)
6.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
7.
Move the brace brackets up or down, on the
vertical roll bar posts, until the sunshade frame
is level to the floor.
Note:
Use a level to make sure that the frame
is level to the ground.
Note:
Use the front or rear mounting holes in
the brace bracket, if you need more adjustability.
8.
Tighten the U-bolt flange nuts, securing the
mounting brackets to the posts.
9.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
10.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
g245151
Figure 5
1.
Flange-head bolt (5/16 x
1-1/4 inches)
3.
Grommet
2.
Small washer
4.
Clip nut
11.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches), a small washer, and a grommet (
12.
Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
4
Summary of Contents for 30669
Page 19: ...Notes...