Toro 30669, Installation Instructions Manual

Page: 3 / 20

Preparing the Machine
1. Park the machine on a level surface.
2. Lower the cutting units and engage the parking
brake.
3. Shut off the engine and remove the key.
Note:
Not every machine uses the same parts to
install the kit.
Identifying the U-Bolts
There are 5 different U-bolts included with this kit.
U-bolts are listed by dimension (span x length) in
the parts list. Refer to
Figure 1 to determine the
dimensions of the U-bolts.
g246183
Figure 1
1. Span 2. Length
Installing the Sunshade
Groundsmaster 5900 Machine
1. Position the ROPS-mount bracket onto the top
of the traction unit roll bar (
Figure 2 ).
Note:
Make sure that the roll bar is centered
in the mount bracket.
g246182
Figure 2
1. Bolt (1/2 x 2-1/2 inch) 3. Flange nut (3/8 inch)
2. Flange nut (1/2 inch) 4. U-bolt (4-7/8 x 4 inches)
2. Install the frame assembly to the ROPS-mount
bracket (
Figure 2 ).
3. Using the mounting holes shown in Figure 2 ,
mount the ROPS-mount bracket to the top of
the roll bar with 2 U-bolts (4-7/8 x 4 inches) and
4 flange nuts.
4. Using the mounting holes shown in Figure 3 ,
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 4 inches) and
2 flange nuts.
3