Toro 30669, Installation Instructions Manual

Page: 10 / 20

g246188
Figure 22
1. Flange nut (3/8 inch) 2. U-bolt (3-7/8 x 2-3/4)
9. On each side of the sunshade frame, loosely
mount a brace to the sixth hole of the bracket
mount with a bolt (1/2 x 2-3/4 inches), washer
(1/2 inch), and flange nut (1/2 inch) as shown
in
Figure 23 .
g267175
Figure 23
1. Flange nut (1/2 inch) 5. Bolt (1/2 x 2-3/4 inches)
2. Mounting hole 6. Brace bracket
3. Brace 7. Bolt (1/2 x 2-1/2 inches)
4. Washer (1/2 inch)
10. Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure 23 .
Note:
The U-bolts are not installed
symmetrically.
11. Move the brace brackets up or down on the
vertical roll bar posts until the sunshade frame
is level to the floor. Use a level to make sure
that the frame is level to the ground. Then,
tighten the U-bolt flange nuts, securing the brace
brackets to the posts.
Note:
Use the front or rear mounting holes,
in the brace bracket, if more adjustability is
required.
12. Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
13. While aligning the mounting holes, position the
sunshade onto the frame as shown in
Figure 24 .
g245151
Figure 24
1. Flange-head bolt (5/16 x
1-1/4 inches) 3. Grommet
2. Small washer 4. Clip nut
14. Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches) a small washer, and a grommet (
Figure
24 ).
15. Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
10