Controls System
Maintenance
Adjusting the Throttle Cable
Service Interval:
After the first 50 hours
Every 400 hours
Adjust the throttle cable (Figure 72) so that the governor
lever on the engine contacts the low and high speed set bolts
before the throttle lever contacts the slot in the control panel.
Figure 72
1.
Throttle cable
Adjusting the Traction Pedal
Linkage
With the traction switch in the mow position (low speed), the
traction pedal should contact the stop just before the pump is
at full stroke to prevent any damage to the pump. If it does
not, perform the following procedure:
1.
Park the machine on a level surface, stop the engine,
and lower the cutting units to the floor. Remove the
ignition key.
2.
Depress the traction pedal until it is at full stroke
(Figure 73). The jam nuts may have to be loosened and
the stop lowered to attain full stroke.
Figure 73
1.
Traction pedal stop
2.
Jam nuts
3.
Release the traction pedal and adjust the stop another
half to full turn so that the pedal contacts the stop just
before full stroke is attained, then, tighten the jam nuts
(Figure 73).
46
Summary of Contents for 30447N
