Toro 30447N, Operator'S Manual

Page: 16 / 68

two positions R (manual reverse) and Auto (normal). Refer
to Engine Cooling Fan Operation in the Operation Section
of manual.
G01 1547
1
2
3
Figure 5
1. Power point 3. Hour meter
2. Engine cooling fan switch
Hour Meter
The hour meter (Figure 5) shows the total hours that the
machine has been operated.
Power Point
The power point (Figure 5) is used to power optional
electrical accessories.
Audible Alarm
To warn bystanders, an alarm will sound if the cutting decks
are lowered with the engine off. The alarm will quit sounding
once the deck lower switch is released. Also, the alarm will
sound if the engine coolant temperature reaches a set-point
that cuts out the PTO operation. The alarm will continue
to sound until the coolant temperature drops below the
set-point or the PTO switch is disengaged.
Cab Controls
Model 30447 only
Wind Shield Wiper Switch
Press front of switch to activate the wind shield wipers
(Figure 6) and rear of switch to turn off the wipers.
Air Conditioning Switch
Press front of switch to activate the air conditioning (Figure 6)
and rear of switch to turn off the air conditioning.
Fan Control
Rotate the fan control knob to regulate the speed of the fan
(Figure 6).
Temperature Control
Rotate the temperature control knob to regulate the air
temperature in the cab (Figure 6).
Figure 6
1. Wind shield wiper switch 5. Hazard light switch
2. Air conditioning switch 6. Turn signal switch
3. Temperature control 7. Dome light switch
4. Fan control
Hazard Light Switch
Press the switch to activate the hazard lights (Figure 6).
Turn Signal Switch
Press the switch to activate the turn signals (Figure 6).
Dome Light Switch
Press the switch to activate the dome light (Figure 6).
Wind Shield Latch
Lift up on latches to open the wind shield (Figure 7). Press
in on latch to lock wind shield in open position. Pull out and
down on latch to close and secure wind shield.
16