Toro 30447N, Operator'S Manual, Page: 26 / 68

Figure 28
1. Tensioning cap 4. Top axle mounting hole
2. Spacers 5. Castor wheel
3. Shims
Wing Cutting Unit Setup
Rotate blade of each spindle until the ends face forward and
backward. Measure from the floor to the front tip of the
cutting edge. Adjust 1/8 inch shims on front castor arm(s)
to match height of cut to decal (Figure 29). For the outside
blade spindle only, refer to Adjusting the Cutting Unit Pitch.
Figure 29
1. Castor arm 3. Castor fork
2. Shims
Matching Height Of Cut Between Cutting Units
1. Position blade side to side on outside spindle of both
wing cutting units. Measure from the floor to the tip
of the cutting edge on both units and compare. These
numbers should be within 1/8 inch (3 mm) of each
other.
2. Add or remove 1/8 inch shims as needed on wing
castor wheels. Recheck measurement between outside
edges of both wing cutting units and adjust as necessary.
Adjusting the Mirrors
Model 30447 only
Rear View Mirror
While sitting in the seat, adjust the rear view mirror
(Figure 30) to attain the best view out the rear window. Pull
the lever rearward to tilt the mirror to reduce the brightness
and glare of light.
Side View Mirrors
While sitting in the seat, have a helper adjust the side view
mirrors (Figure 30) to attain the best view around the side of
the machine.
Figure 30
1. Side view mirrors 3. Lever
2. Rear view mirror
Aiming the Headlights
1. Loosen the mounting nuts and position each headlight
so that it points straight ahead. Tighten the mounting
nut just enough to hold the headlight in position.
2. Place a flat piece of sheet metal over the face of the
headlight.
3. Mount a magnetic protractor onto the plate. While
holding the assembly in place, carefully tilt the headlight
downward 3 degrees, then tighten the nut.
4. Repeat the procedure on the other headlight.
Starting and Stopping the
Engine
Important:
The fuel system will automatically bleed
itself when any of the following situations occur:
•
Initial start up of a new machine.
•
The engine has ceased running due to lack of fuel.
•
Maintenance has been performed upon the fuel system
components.
Refer to the Bleeding Air from the Injectors.
26