Transporting
Use the transport latches when transporting over long
distances, rough terrain, or when trailering.
After Operating
To ensure optimum performance, clean the underside of the
mower housing after each use. If residue is allowed to build
up in the mower housing, cutting performance will decrease.
Also, remove any debris which may have collected between
the deck lift cylinders and the foam deck pads (Figure 35).
Figure 35
1.
Deck lift cylinder
2.
Foam deck pad
Cutting Unit Pitch
A blade pitch of 1/4 inch (6 mm) is recommended. A pitch
larger than 1/4 inch (6 mm) will result in less power required,
larger clippings, and a poorer quality of cut. A pitch less than
1/4 inch (6 mm) will result in more power required, smaller
clippings and a better quality of cut.
Maximizing Air Conditioner
Performance
•
To limit solar heating, park the machine in a shaded area
or leave the doors open in direct sun.
•
Check to make sure the air conditioning condenser fins
are clean.
•
Operate the air conditioner blower at the mid speed
setting.
•
Verify continuous seal between the roof and the headliner.
Correct as required.
•
Measure the air temperature at the front center vent in
the headliner (Typically stabilize at less than or equal to
50 degrees F.)
•
Refer to the Service Manual for additional information.
30
Summary of Contents for 30447N
