Toro 30411, Service Manual

Page: 87 / 262

Groundsmaster 4100--D Hydraulic System Page 4 -- 45
Procedure for Rear Traction Circuit (RV5) Relief
Pressure Test
1. Make sure hydraulic oil is at normal operating tem-
perature by operating the machine for approximately 10
minutes. Make sure the hydraulic tank is full.
2. Park machine on a level surface with the cutting
decks lowered and off. Make sure engine is off and the
parking brake is engaged.
CAUTION
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS, and Pre-
cautions for Hydraulic Testing at the beginning
of this section.
3. Connect a 1000 PSI gauge to test port on 2WD/4WD
control manifold under radiator (Fig. 37).
4. After installing pressure gauge, start engine and run
at idle speed. Check for hydraulic leakage and correct
before proceeding with test.
5. Operate the engine at full engine speed (2730 + 30
RPM) .
6. Operate the machine in 4WD with the cutting decks
lowered. Drive down a slope in a forward direction, de-
crease pressure on the traction pedal, and monitor the
pressure gauge. Pressure should increase until the re-
lief valve (RV5) lifts. Record test results.
GAUGE READING TO BE 750 PSI (approximate).
7. Relief valve (RV5) is located on the lower, front side
of the 2WD/4WD control manifold (Fig. 38). Adjustment
of the relief valve can be performed as follows:
NOTE: Do not remove the relief valve from the hydrau-
lic manifold for adjustment.
A. To increase relief pressure setting, remove cap
on relief valve and turn the adjustment socket on the
relief valve in a clockwise direction. A 1/8 turn on the
socket will make a measurable change in relief pres-
sure (Fig. 39).
B. To decrease pressure setting, remove cap on re-
lief valve and turn the adjustment socket on the relief
valve in a counterclockwise direction. A 1/8 turn on
the socket will make a measurable change in relief
pressure (Fig. 39).
C. Recheck relief pressure and readjust as needed.
8. Disconnect pressure gauge from test port.
1. 2WD/4WD control manifold
2. Relief valve test port
Figure 37
1
2
1. Manifold: lower side 2. Relief valve (RV5)
Figure 38
2
1
Figure 39
1. Relief valve cap 2. Adjustment socket
2
1
Hydraulic System