Toro 30411, Service Manual

Page: 228 / 262

Groundsmaster 4100−D Cutting Deck
Page 8 − 2
Specifications
MOUNTING: Cutting deck is supported by lift arms con-
trolled with hydraulic lift levers.
CONSTRUCTION: Deck chamber is welded 12 gauge
steel construction reinforced with channels and plates.
HEIGHT−OF−CUT RANGE: 1” to 5” (2.54 cm to 12.7
cm) adjustable in 1/2” (1.27 cm) increments. Center
deck height−of−cut adjustment is achieved by changing
spacers on castor wheels and adjusting length of deck
support chains. Wing deck adjustment achieved by
changing spacers on castor wheels, re−positioning the
castor wheel axles in the castor forks, and securing the
castor wheel bracket to the correct height−of−cut brack-
et holes.
DECK DRIVE: Closed loop hydraulic system operates
hydraulic motor on each cutting deck section. Motor
drives one spindle directly with remaining deck section
spindle(s) driven by B section kevlar v−belt(s). Blade
spindles are 1−1/4” (3.17 cm) shafts supported by
greaseable, tapered roller bearings.
CUTTING BLADE: Cutting blade dimensions are 19”
(48.3 cm) long, 2.5” (6.4 cm) wide, and .250” (.64 cm)
thick. Anti−scalp cup installed on each cutting blade.
Center deck includes three blades and each wing deck
includes two blades.
WIDTH OF CUT: Front deck provides 54” (137.2 cm)
width of cut. Each side deck has 37” (94 cm) width of cut.
Total width of cut is 124” (315 cm).
DISCHARGE: Clippings are discharged from the rear of
the cutting deck.
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. Front deck suspended
from lift arms and has six castor wheels, two adjustable
skids, and five anti−scalp rollers.