Toro 30411, Service Manual

Page: 206 / 262

Groundsmaster 4100−D Page 6 − 16 Axles, Planetaries, and Brakes
5. Remove the knuckle pin mounting screws and the
knuckle pin. Remove the gasket and any remaining gas-
ket material from either mating surface (Fig. 16).
6. While holding the bevel gear case, tap the upper end
of the bevel gear shaft out of the upper bearing and up-
per bevel gear.
7. Pull the bevel gear case from the axle case and re-
move the upper bevel gear, and collar from the gear
case.
8. Remove the axle case cover screws, cover, and the
O-ring from the axle case.
9. Remove the plug and sealing washer from the center
of the axle case cover. While holding the axle case cov-
er, lightly tap the lower end of the bevel gear shaft out of
the lower bearing and lower bevel gear.
10.Remove and discard bevel gear shaft seal from axle
case (Fig. 16).
1. Knuckle pin
2. Mounting screw (4 used)
3. O−ring
4. Bevel gear case
5. Upper
bearing
6. Bevel gear shaft
7. Collar
8. Upper bevel gear
9. Lower bevel gear
10. Lower bearing
11. Axle case
12. Axle case cover
13. O-ring
14. Shaft seal
15. Bushing
Figure 16
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
17 to 20 ft−lb
(23 to 27 N−m)
17 to 20 ft−lb
(23 to 27 N−m)
Threadlocking
Compound
Inspection
1. Measure the knuckle pin O.D. and the axle case sup-
port bushing I.D. to determine the bushing to pin clear-
ance (Fig. 17). Replace components as necessary.
BUSHING TO PIN CLEARANCE:
0.002 to 0.016 in. (0.05 to 0.40 mm)
KNUCKLE PIN O.D. (Factory Spec.):
0.982 to 0.983 in. (24.95 to 24.98 mm)
AXLE CASE SUPPORT BUSHING I.D.
(Factory Spec.):
0.984 to 0.987 in. (25.00 to 25.08 mm)
2. Inspect all gears, shafts, bearings, cases, and cov-
ers for damage and wear. Replace components as nec-
essary.
1. Knuckle pin 2. Axle case support
Figure 17
1
2