Toro 30411, Service Manual

Page: 239 / 262

Groundsmaster 4100−D Cutting Deck Page 8 − 13
Wing Deck Latch
Disassembly (Fig. 11)
1. Raise wing deck to transport position. Carefully ro-
tate latch to closed position.
2. Loosen lug nut to release compression spring ten-
sion.
3. Remove retaining ring and flat washer from bottom
of latch pin. Rotate lug nut enough to allow latch pin to
be removed from latch.
4. Remove lug nut from spring support. Remove latch
assembly from deck.
5. Disassemble latch (items 1 through 8) using Figure
11 as a guide.
Assembly (Fig. 11)
1. Assemble latch (items 1 through 8) using Figure 11
as a guide.
2. Slide spring onto spring support and insert end of
spring support into hole located on underside of center
deck. Start lug nut (tapered side towards plate on deck)
onto spring support.
3. Tighten lug nut until holes in front of deck align with
bushings in latch. Insert latch pin with retaining ring
down through deck and latch. Secure latch pin on under-
side of deck with flat washer and retaining ring.
4. Carefully rotate latch to the open position. Lower
wing deck.
5. Lubricate latch grease fitting.
1. Latch
2. Grease
fitting
3. Lock roller
4. Bushing
5. Flange
bushing
6. Cap screw (3 used)
7. Spring
support
8. Lock nut (3 used)
9. Retaining
ring
10. Flat washer
11. Compression spring
12. Lug nut
13. Latch pin
14. Center deck
Figure 11
5
6
1
7
3
8
10
11
2
9
4
13
9
14
12
3
4
5
4
Cutting Deck