Toro 30411, Service Manual

Page: 41 / 262

Groundsmaster 4100−D Page 3 − 19 Kubota Diesel Engine (Rev. A)
Disassembly
1. If engine is in machine, hydraulic pump assembly
needs to be removed from engine before coupling can
be serviced (see Pump Assembly in Chapter 4 − Hy-
draulic Systems).
2. Remove pump adapter plate, spring center coupling,
and coupling spacer from engine using Figure 16 as a
guide.
Assembly
1. Position coupling spacer to engine and align mount-
ing holes. Use two shoulder bolts and lockwashers in the
positions shown in Figure 17 to secure the spacer to the
half threaded holes in engine flywheel. Torque shoulder
bolts from 17 to 21 ft−lb (23 to 28 N−m).
2. Install four cap screws and lockwashers to coupling
spacer and flywheel. Torque cap screws from 17 to 21
ft−lb (23 to 28 N−m).
3. Place dowels in locating holes of coupling spacer
(Fig. 17).
4. Position spring center coupling (coil springs toward
engine (Fig. 18)) over dowels. Secure coupling to cou-
pling spacer with cap screws and lockwashers. Torque
cap screws from 35 to 43 ft−lb (48 to 58 N−m).
5. Install plate pins into engine casting. Position pump
adapter plate to engine using plate pins as alignment
points. Secure adaptor plate with cap screws and lock
washers using a star pattern tightening procedure.
6. If engine is in machine, install hydraulic pump as-
sembly (see Pump Assembly in Chapter 4 − Hydraulic
Systems).
Figure 17
1. Coupling spacer
2. Shoulder bolt position
3. Cap screw position
4. Dowel
position
2
3
1
2
4
3
4
UP
Figure 18
Engine Side
Spring Center
Coupling
Hydraulic
Pump Side
Kubota
Diesel Engine