![Toro 110-2626 Installation Instructions Manual Download Page 4](http://html1.mh-extra.com/html/toro/110-2626/110-2626_installation-instructions-manual_1134419004.webp)
Procedure
Description
Qty.
Use
15
No parts required
–
Install the seat shroud, ROP shield, and
coolant tank.
16
No parts required
–
Install the seats and center console.
17
No parts required
–
Install the hood.
18
No parts required
–
Install the bed.
1
Preparing to Install the Kit
No Parts Required
Procedure
Note:
If you are installing the remote hydraulics manifold
kit on a Workman model with a serial number in the range of
240000000 through 249999999, you must replace the switch
in this kit. Purchase the new switch (Toro Part No. 105-0023)
from your Toro Distributor and install the switch.
1.
Move the machine to a clean and level surface.
2.
Shut off the engine, set the parking brake, and remove
the key from the key switch.
3.
Remove the bed from the machine; refer to the
Operator’s Manual
for your Workman model for the bed
removal procedure.
4.
Disconnect the battery as follows:
A.
Squeeze the battery cover to release the tabs from
battery base (
Figure 1
B.
Remove the battery cover from the battery base
(
).
C.
Remove the terminal of the positive battery cable
from the battery post (
Note:
Ensure that the terminal positive battery
cable does not touch the battery post.
G022071
1
2
3
4
Figure 2
1.
Terminal cover
3.
Battery post
2.
Positive terminal
4.
Battery
5.
Bleed the hydraulic pressure from the machine by fully
moving the lift control for the cargo box forward and
backward several times (
).
Note:
You must bleed the hydraulic pressure from the
machine with the engine shut off.
4