Drive System
Maintenance
Changing the Front Differential
Oil (Four Wheel Drive Models
Only)
Service Interval:
Every 800 hours
1. Position the vehicle on a level surface, stop the
engine, engage the parking brake and remove the key
from the ignition switch.
2. Clean the area around the drain plug on the side of
the differential (Figure 55). Place a drain pan under
the drain plug.
Figure 55
1.
Fill/check plug
2.
Drain plug
3. Remove the drain plug and let the oil flow into the
drain pan. Install and tighten the plug when the oil
stops draining.
4. Clean the area around the fill/check plug on the
bottom of the differential.
5. Remove the fill/check plug and add Mobil 424
hydraulic oil until the oil is up to the hole.
6. Install the fill/check plug.
Inspecting the Constant
Velocity Boot (Four Wheel
Drive Models Only)
Service Interval:
Every 200 hours
Inspect the constant velocity boot for cracks, holes, or a
loose clamp. Contact your Authorized Toro Distributor
for repair if you find any damage.
Adjusting the Shift Cables
Service Interval:
After the first 10 hours
Every 200 hours
1. Move shift lever to the Neutral position.
2. Remove the clevis pins securing the shift cables to
the transaxle shift arms (Figure 56).
Figure 56
1.
Shift arm (1st—Rev.)
3.
Shift arm (High—low)
2.
Shift arm (2nd—3rd)
3. Loosen the clevis jam nuts and adjust each clevis
so cable free play is equal forward and backward
relative to the hole in the transaxle shift arm (with
the transaxle lever free play taken up in the same
direction).
4. Install the clevis pins and tighten the jam nuts when
finished.
Adjusting the High–Low Cable
Service Interval:
Every 200 hours
1. Remove the clevis pin securing the High–Low cable
to the transaxle (Figure 57).
2. Loosen the clevis jam nut and adjust the clevis
so that the clevis hole aligns with the hole in the
transaxle bracket.
3. Install the clevis pin and tighten the jam nut when
finished.
Adjusting Differential Lock
Cable
Service Interval:
Every 200 hours
1. Move the differential lock lever to the Off position.
47
Summary of Contents for 07367TC
