Figure 15
1.
Filler cap
2.
Dipstick
3. If the oil level is low, remove the filler cap (Figure 15)
and add enough oil to raise the level to the Full
mark on the dipstick.
Note:
When adding oil, remove dipstick to allow
proper venting. Pour oil slowly and check the level
often during this process.
Do not overfill.
Important:
When adding engine oil or filling
oil, there must be clearance between the oil fill
device and the oil fill hole in the valve cover as
shown in Figure 16. This clearance is necessary
to permit venting when filling, which prevents
oil from overrunning into the breather.
Figure 16
1.
Note clearance
4. Install the dipstick firmly in place.
Adding Fuel
The Toro® Company strongly recommends the
use of fresh, clean, unleaded regular grade gasoline
in Toro gasoline powered products. Unleaded
gasoline burns cleaner, extends engine life, and
promotes good starting by reducing the build–up
of combustion chamber deposits. Use a minimum
octane rating of 87.
Fuel tank capacity:
6.5 US gallons (25 l).
Note:
Never use methanol, leaded gasoline,
gasoline containing methanol, gasoline containing
more than 10% ethanol, gasoline additives, or white
gas because engine fuel system damage could
result.
21
Summary of Contents for 07367TC
