Toro 07236, Operator'S Manual

Page: 7 / 52

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Steering wheel 1
Cover 1
1
Washer (1/2 inch) 1
Install the steering wheel (TC models
only).
2
No parts required
–
Connect the battery (TC models only).
3
No parts required
–
Check the fluid levels and tire pressure.
4
No parts required
–
Burnish (break-in) the brakes.
Operator's Manual 1
Engine owner's manual 1
Registration card 1
Predelivery Inspection Form 1
Certificate of Quality 1
5
Key 2
Read the Operator's Manual and view
the setup material before operating the
machine.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Installing the Steering
Wheel
TC Models Only
Parts needed for this procedure:
1 Steering wheel
1 Cover
1 Washer (1/2 inch)
Procedure
1. If the cover is installed, remove it from the hub
of the steering wheel (
Figure 3 ).
2. Remove the locknut (1/2 inch) from the steering
shaft (
Figure 3 ).
3. Slide the steering wheel and washer (1/2 inch)
onto the steering shaft (
Figure 3 ).
4. Secure the steering wheel to the shaft with the
locknut (1/2 inch) and tighten it to 27 to 34 N∙m
(20 to 25 ft-lb).
5. Install the cover on the steering wheel ( Figure 3 ).
g033840
Figure 3
1. Cover 4. Steering wheel
2. Locknut (1/2 inch) 5. Steering shaft
3. Washer (1/2 inch)
7