1N15-002
Pirate Blasta Installation Manual V1 03/03
The Site
1. Before starting the installation assure yourself that the site is prepared
according to our instructions. There should be a hard and flat level area at
least 3M wide and 2.4M deep. The area must be smooth with no upward
projections that could damage the pool liner. There should be a power supply
and water supply to the rear of the area. See sheet 1 of appendix A.
Assembly
1. Using the assembly drawings at appendix A, identify the various parts of the
cabinet and its fittings. Ensure that you are familiar with the assembly
procedure.
2. Assemble the game in accordance with the assembly instructions at appendix
A, being careful to use the correct fasteners in all locations.
Warning!
Do not connect the mains electricity supply lead to the mains supply outlet at
this time.
3. You should now have the game assembled with water in the tank and be
ready to connect the power and test the unit.
Note!
The sealant used in the construction of the unit should be allowed to set
before proceeding. The time taken for this will depend on the ambient
temperature and humidity. Test a small area with your finger to ensure it is
set before proceeding.
4. If the game is to be used in the United Kingdom connect the supplied residual
current device (RCD) to the input end of the power supply lead or connect the
power supply lead to a supply which is protected by a fixed RCD. If the game
is to be used outside of the United Kingdom connect the power supply lead to
a supply which is protected by a fixed RCD.
Warning!
Danger of electrocution! Step 4 should only be completed by a suitably
experienced electrician. Do not operate this unit unless the power is supplied
through a working residual current device.
5. Turn on the power supply and immediately test the RCD to ensure its correct
operation. Do not proceed if the RCD is not fully functional.
©Tornado International Ltd. 2003
-6-
Confidential
