18
1. A the end of the washing
cycle, pressing the push
button (1), the functioning of
BREAK WASHING is chosen.
When the signal lamp (2) is
on, then the machine then
the machine is in BREAK
WASHING mode. In this way
automatically the brushes lift,
the solenoid valve shuts down
and it is possible to finish the
drying operation for a total
time of about 15 seconds,
afterwards also the squeegee
is lifted and the suction stops.
NOTE: all these phases are
carried out with the machine
operating, so that the
squeegee can dry the cleaning
area from the “drying phase of
the brushes” and furthermore
can dry the suction hose of its
dirty water.
At any time it is possible to
interrupt the procedure BREAK
WASHING by stopping the
drive.
2. During the phase of
BREAK WASHING, when the
accelerator pedal is released
for more than 3 seconds,
the squeegee raises itself
and the suction switches off
automatically.
3. After three seconds, the
accelerator can be pressed
again, if a machine’s transfer
has to be made (you can make
the transfer even if the pedal is
not lifted once the 15 seconds
have passed).
4. Turn the switch key
counterclockwise to switch off
the machine.
DAILY MAINTENANCE
•
Solution and recovery tanks
• Solution and recovery filters
• Squeegee with their rubbers
and hoses
• Brushes
must be carried out using
gloves to protect from contact
with dangerous solutions.
RECOVERY TANK EMPTYING
AND CLEANING
1. Remove the exhaust hose
(1) from the holding bracket.
2. Remove the plug (2) from
the exhaust hose by pulling
on the lever (3) and empty the
recovery tank into appropriate
containers, in compliance with
the respective rules.
3. Take off suction cover (4)
after rotating the blocking
levers (5).
4. Take off the filter and filter
protection (6).
5. Rinse the inside of the tank
with a water jet.
6. Reassemble all parts.
SUCTION FILTER CLEANING
1. Take off suction cover (4)
after rotating the blocking
levers (5).
2. Take off the filter (8) and the
filter protection (6).
3. Clean all parts with a water
jet, especially the inside
surfaces and the filter bottom.
4. Reassemble all parts.
The mode (BREAK WASHING)
is specific for the transfer
at the end of the cleaning
operation.
ATTENTION:
Re-start the cleaning
operation:
A. by pressing the push button
(4) the automatic (AUTO)
functioning is chosen to start
working in automatic mode.
B. by pressing the push
button (3) the manual (MAN)
functioning is chosen to start
working in manual mode and
all functions have to be re-
established manually.
All the following maintenance
and cleaning operations
that refer to the following
components that are in
contact with liquids and
therefore:
ATTENTION:
