Page
17
•
Install one 1/4”-20 x 3/4” button head bolt up into each hole
the air dam and through the tab on the side of the receiver.
•
Secure each bolt with one 1/4” SAE flat washer and one 1/4”-
20 thin nylock nut. Tighten until snug. Do not over tighten as
it may deform the plastic.
Step 10
•
Install one 3/8” hole plug into the holes left in the bumper by
the original license plate bracket.
•
Install one 1/4”-20 x 1/2” button head bolt with one 1/4” SAE
flat washer into each hole in the license plate and through the
license plate bracket. Secure each bolt with one 1/4” SAE flat
washer and one 1/4”-20 thin nylock nut. See Figure 10.1.
•
Slide the license plate bracket into the hitch receiver and pin it
in place using the supplied 5/8” hitch pin and clip.
Installation is complete.
Figure 10.1
