Page 4
Step 1:
•
Place the transmission in park and chock the rear tires to prevent
the truck from rolling.
•
Raise the front of the vehicle and place the front axle on jack
stands.
•
If equipped, remove the license plate, then the factory license
plate bracket. The bracket is held in with four self-tapping
screws.
Step 2:
•
Remove the 14 nuts attaching the lower air dam to the front
bumper. See Figure 2.1. The middle four nuts can be accessed
through the front opening in the air dam.
•
Using a screwdriver, carefully disconnect the two push clips in the
bottom of the air dam.
•
Using a screwdriver, carefully disconnect the two remaining clips
holding the air dam to the bumper.
•
Set the air dam aside.
