This product is a hydraulic trolley jack for lifting motor vehicles. It is intended for use as a lifting device only.
Ensure that the load to be lifted does not exceed the maximum permissible load of the jack. The maximum
load of 2 tonnes must not be exceeded otherwise the jack may become damaged and safety compromised.
Use the jack on a firm, even surface only. Instability or slipping of the load may occur on soft or uneven
surfaces. Consequential damage to the vehicle or persons cannot then be precluded. (Risk of accident!).
Make sure there are no persons inside the vehicle being lifted. Position the hydraulic jack so that no part of
your body will be under the vehicle while it is being lifted. Never work under a car that is being supported
only by the hydraulic jack. Always use additional supports. Before lowering the hydraulic jack, ensure there
are no persons or objects under the vehicle. Never leave the hydraulic jack unattended for longer periods
when it is supporting a load as it can lose pressure and begin to sink for design-related reasons. Therefore
place something underneath the lifted load immediately! Never get into the vehicle or start its engine while it
is on the hydraulic jack.
1.1 General safety
• The jack is only designed for lifting the load and supporting the load when an additional high strength bolt
is used;
• Visually and operationally inspect jack before each use; do not use the jack if damaged;
• Warning: if any part of jack fails to work properly, discontinue and have repaired;
• Warning: Never attempt to repair jack while jack is under load;
• Warning: Ensure jack to connect and support on suitable base (at least a 400 x 300 dimension with
enough strength) so it will not slip or shift during operations and load is properly supported at lift point to
prevent shifting;
• All persons shall be clear of load being raised or lowered. Never work under a raised load unless using
additional supports and insert ½” bolt (not included) through hole in steel beam immediately below lifting
mechanism (to act as a safety pin);
• Warning: never exceed the rated load;
• Jack must have a 75 kg load or more to activate the lowering step by step, otherwise lifting beak will drop
suddenly;
• Use hand power only, do not use additional devices on handle to provide extra manpower;
• Do not use the jack for purpose other than for which it is designed;
• Front and back of the rail must be kept rust free, do not use it when rusting happened;
• It is necessary that the operator can watch the lifting device and the load during all movements;
1.2 When used to jack a vehicle
• Ensure jack to connect and support on suitable base (specified in 1.1);
• Ensure the vehicle handbrake is engaged, engine is switched off and transmission is in gear (or “PARK” if
automatic);
• Ensure min. distance of 0.5 m between vehicle and static objects such as doors, walls, etc.;
• Check the lifting point is stable and correctly positioned on the lifting beak;
• Do not allow the vehicle to move while supported by the jack, or use the jack to move the vehicle.
2. INSTRUCTION & SPECIFICATIONS
1. SAFETY PRECAUTIONS
Model
Weight (kg)
TRA8485 TRA8605
400
125-1020
500
1600
2000
13
400
125-1330
500
1600
2000
14.3
Rated load (kg)
Lifting range (mm)
Max. supporting load(additional high
strength bolt is used) (kg)
H≥ 500 mm
300 ≤H< 500 mm
125 ≤H< 300 mm
