TOPTEK TOPVERT S1 Series, Quick Start Manual

Page: 11 / 52

TOPVERT S1 Series
E-
10
18: Remain time of the executing MSS Run
19: (Factory Reserved)
20: (Factory Reserved)
21: Accumulated power-up Day (day)
22: Accumulated power-up time (hh:mm)
23: (Factory Reserved)
24: (Factory Reserved)
25: (Factory Reserved)
26: The signal of AVI analog input (Vdc)
27: The signal of ACI analog input (mAdc)
28: (Factory Reserved)
29: (Factory Reserved)
3
0〜33
: (Factory Reserved)
34: Over-Torque detection level 1 (Pr5-16)
35: Motor 1 Auto torque boost (Pr5-01)
36~37: (Factory Reserved)
38: Stall level while run in constant torque area
(Pr5-12)
39
〜
52: (Factory Reserved)
53: Output power (kW)
54: Output capacity (kVA)
55
：
(Factory Reserved)
56: The temperature of IGBT module--TH1 ( °C)
57: The temperature of environment or fin (TH2)
(°C)
58: (Factory Reserved)
59: (Factory Reserved)
60: Drive overload accumulated time (OL)
61~63
：
(Factory Reserved)
64: DC Bus voltage upon a fault (Vdc)
65: Output voltage upon a fault (Vac)
66: Output frequency upon a fault (Hz)
67: IGBT module temperature upon a fault
( °C)
◎
68: Output current value upon a fault (Aac)
69
︰
Temperature of Fin or environment
upon a fault ( °C)
◎
70~86
︰
(Factory Reserved)
87: DC Bus ripple voltage (Vdc)
◎
88: (Factory Reserved)
◎
0
〜
39 (no use)
Pr0-08
User-Defined coefficient
K
40
〜
60000 (the corresponding value for Pr1-00--
the max. frequency).
0
Pr0-09 The decimal places
0~3 (0=Without d.p., 1= 1 digit d.p., 2=2 digit
d.p., 3=3 digit d.p.)
0
Pr0-10 Firmware version Read-only x.xx
0
FWD/REV direction command will be
store
Bit0
1 FWD/REV direction command not store
0
Frequency command from PU will be
store
Bit1
1 Frequency command from PU not store
0
RS-485 frequency command will be
store
Bit2
1 RS-485 frequency command not store
0
Up/Down frequency command will be
store
Pr0-11 EPROM store set
Bit3
1
Up/Down frequency command not
store
b00000