14
When cutting round stock, firmly secure it.
Before starting work, check saw blade, upper and lower blade guard are in proper working order.
Replace damaged parts immediately
Assume correct work position (the band saw blade’s teeth must point towards the operator).
Be careful of the risk of kickback.
1. Switch
action
To start the band saw, turn on the switch.
To stop the band saw, turn off the switch.
To use led light, turn on the led light switch.
The led light is an alternative assembly part.
Your machine may not have this part.
2. Using miter gauge
The miter gauge is inserting into the table slot from the table
front edge.
For miter cuts, the miter gauge can be turned to 60º in both
directions.
To set a miter angle: loosen lock knob by turning it
counter-clockwise.
Warning: When cutting with miter gauge, the lock handle
must be firmly tightened.
3. Using push stick
The push stick is an alternative assembly part. Your machine may not have this part.
The push stick serves as an extension of the hand and protects against accidental contact with saw blade.
When the push stick is not used, it can be stored on the hook provided at the band saw frame.
Replace push stick if damaged.
4. Sawing
Set upper blade guide 3mm above the workpiece.
Place workpiece on the table.
Plug
in.
Start
saw.
Cut workpiece in a single pass.
Switch off if no further cutting is to be done immediately afterwards.
Switch
Miter gauge
Lock knob
Push stick
Led light switch