23
9. INSTALLING THE IP-S3 CUBE
After mounting the IP-S3 cube on the roof of the vehicle, connect it to the timing box using the included
cables. Keep the rear window slightly open to route the cables to the timing box. Do not allow any slack
in the cables.
Fixing the timing box
To prevent the timing box from moving while the car is running, adhere Velcro tape to the rear surface
of timing box as shown below.
Connecting the power cable
1. Connect the IP-S3 side connector ([Timing Box Side] is written on the tag) of the power cable to
the power supply port (POWER) of timing box. Do not supply power to the timing box.
• If power is supplied to the box at this point, it may draw too much power and cause the connector
to fail.
• The above illustration shows the position of each connector.
• Do not connect the cables incorrectly.
• The color sheet on the timing box shows the color of each cable tag.
9.2
Connect the Cables
Warning
To avoid electric shock, turn off the car engine before connecting the power cables.
Timing box
Velcro tape
