Topcon HiPER GD, Operator'S Manual

Page: 98 / 180

Setup and Survey
Topcon HiPer GD and HiPer GGD Operator’s Manual
3-16
that prevents a clear view of the sky), the receiver will be
re-initialized on the fly.
After the survey completes, raw data collected by the
receivers are downloaded onto a computer and processed
using post-processing software (for example, Pinnacle).
1. Using PC-CDU, configure and set up the Base as
described in “Static Survey” on page 3-10.
2. Using PC-CDU, click Configuration->Receiver
->MINTER, and configure the Rover with the
following parameters, then click Apply (Figure 3-10 on
page 3-14):
• FN Key Mode, Occupation Mode Switch – enable
• Initial data collection dynamic mode, Kinematic –
enable
3. Set up the Rover at a starting point with unknown
coordinates and press the power key. Pause for several
minutes while the receiver compiles an almanac.
4. Check the STAT light for satellites tracked.
5. Press the FN key for one to four seconds to begin
logging data in kinematic mode (the antenna status is
kinematic).
6. Move the Rover receiver along the selected trajectory.
7. Once the Rover receiver reaches the end point of the
trajectory, pause for several minutes.
8. When finished, press the FN key to stop logging data
and turn off the Rover.